Thank you!
Very nice model! By removing the 5th lead, finally I was able to create the 11-7A9 footprint. Thank you very much!
Дякую.
40,5mil off set to pin 1, 25mil Standoff height. For Altium.
An accurate model. Visual representation is excellent. The fact that the pins are straight is wonderful, the only thing missing that would make it 5 s...
I use this part with Altium 14, no problem found. Thank you for your time.
The straight pins are better for PCB design because they fit the vertical PCB holes... angled pins stick out of the pads of the holes looking rather o...
The only enhancement one could have asked for is to have the pins at the typical DIP bend angle, rather than a perfect right angle. Thanks for a great...
Excellent model Nice job
請選擇您要標示為不適當的標籤。