Need a SOT-563 model, this one seems fine.

I needed a simple model and this worked.  However, there is room for improvement.  Pitch is off and pin 1 designator should be added.

Well done

Some fine tuning required

The pitch is slightly larger, as it was mentioned in previous posts. Marking of pin 1 is the only thing I added after download.

The model is well-matched with footprint from Texas Instruments but there is no 1st pin dot. Even if the pitch is 0.508 instead of 0.5, it is not noti...

I imported the .stp file in altium (AD19) and the pin pitch seems to be 0.508mm while it should be 0.5mm.
I was able to get a correct model from Texas...

good!

Very good!

THANK YOU